Symbols, abbreviations, or full names for units of length,Īrea, mass, pressure, and other types. Convert psi to bar, kgf/cm2 to psi, bar to kgf/cm2, and other units like pa, mmH2O, inches H2O, psf and atmosphere with DigiKeys pressure measurement. You can find metric conversion tables for SI units, as wellĪs English units, currency, and other data. 40 psi (2.8 bar) regulator for high flow 0.5 gpm to 35 gpm flow Can be installed above or below the ground 1 (26/34) female-threaded inlet and outlet. Its official symbol is "bar" the earlier "b" is now deprecated, but still often seen especially as "mb" rather than the proper "mbar" for millibars.Ĭonversion calculator for all types of measurement units. The word bar is of Greek origin, báros meaning weight. The bar is a measurement unit of pressure, equal to 1,000,000 dynes per square centimetre (baryes), or 100,000 newtons per square metre (pascals). One psi is 1/14.50377 bar, and we can therefore make the following psi to bar formula: psi × 1/14.50377 bar With this formula, we can calculate the exact fractional answer and the approximate decimal answer, like this: psi × 1/14.50377 bar 40 × 1/14.50377. 1 2 By the barometric formula, 1 bar is roughly the atmospheric pressure on. A bar is a little less than the average atmospheric pressure on earth at sea level. A pressure of 1 bar is slightly less than the current average atmospheric pressure on Earth at sea level (approximately 1.013 bar). It is the pressure resulting from a force of one pound-force applied to an area of one square inch. The bar is a metric unit of pressure, but not part of the International System of Units (SI) it is defined as 100,000 Pa (100 kPa). The pound per square inch or, more accurately, pound-force per square inch (symbol: psi or lbf/in² or lbf/in²) is a unit of pressure or of stress based on avoirdupois units. A pressure of 1 Pa is small, which approximately equals the pressure exerted by a dollar bill resting flat on a table. The SI unit of pressure is the pascal, symbol Pa. You can do the reverse unit conversion fromīar to psi, or enter any two units below: Enter two units to convert From: Pressure (the symbol: p) is the ratio of force to the area over which that force is distributed, and it is the amount of force acting per unit area.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |